Training
OEM Training
Volvo Training
Introduction To Volvo Collision Repair Assessment
Volvo Non-Structural Repair Assessment
Volvo Damage Analysis And Electromechanical Repair Assessment
Knowledge of subjects in general collision repair is necessary for you to get the most benefit, and achieve success, in the Volvo-specific programs. I-CAR provides training on a variety of collision repair subjects. Though some of these programs are not required for the Volvo Body and Paint Service Center Programs, your chances of success in the Volvo-specific programs will improve by first achieving a solid, general training base. This assessment is designed to help you identify any possible weaknesses in the various collision repair subjects. Please complete the questions below and hit "Continue Assessment".
1. Which of these is a polyolefin plastic? A B C D
A. Polypropylene B. Polycarbonate C. Polyurethane D. Polyamide
2. A two-sided plastic adhesive repair is being made on a TPO rocker cladding. Technician A says that reinforcement tape may be applied to the front side of the part. Technician B says that reinforcement tape may be applied to the backside of the part. Who is right? A B C D
A. A only B. B only C. Both A and B D. Neither A nor B
3. Wicking could occur when a liquid cleaner is used on which of these plastics? A B C D
A. SMC B. TPO C. RIM D. ABS
4. Technician A says that refinish adhesion promoters may be substituted for plastic adhesion promoters. Technician B says that adhesion promoters are applied to polyolefins. Who is right? A B C D
5. Technician A says that a cohesive failure, when doing a plastic adhesive repair, may be caused by the repair material. Technician B says that an adhesive failure, when doing a plastic adhesive repair, may be caused by poor surface preparation. Who is right? A B C D
6. When performing a plastic welding rod adhesion test, the rod to use should be the rod that: A B C D
A. melts. B. does not melt. C. sticks. D. does not stick.
7. An adhesion-type of plastic weld is made on: A B C D
A. PE mounting tabs. B. ABS grilles. C. PUR bumpers. D. most interior plastics.
8. Which of these plastics will likely smear when performing a sanding test? A B C D
A. PA B. GTX C. TPO D. PC
9. The stitch-tamp plastic welding method is used to repair which of these plastics? A B C D
A. PC B. ABS C. PE D. TEO
10. A plastic welding rod should match the: A B C D
A. color of the plastic. B. flexibility of the plastic. C. ISO code for the plastic. D. texture of the plastic.
